Table of Contents
Advertisement
Blower Unit Removal and
Installation
SRS components are located in this area. Review the
SRS component locations, '99-01 models (see page 23-
18), '02 model (see page 23-19), '03-04 models (see
page 23-20), and the precautions and procedures (see
page 23-21) before performing repairs or service.
1. Make sure you have the anti-theft code for the radio
and the navigation system, then write down the
frequencies for the radio's preset buttons.
2. Disconnect the negative cable from the battery.
3. Remove the evaporator (see page 21-42).
4. Remove the front passenger's airbag (see page 23-
370).
5. Disconnect the connectors (A) from the blower
motor, the blower resister and the recirculation
control motor, then remove the wire harness clips
(B). Remove the mounting nuts, the mounting bolt
and the blower unit (C).
6 x 1.0 mm
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
B
6. Install the unit in the reverse order of removal, and
note these items:
• Make sure that there is no air leakage.
• For evaporator and A/C-related infomation, refer
to evaporator removal and installation (see page
21-42).
• Do the PCM idle learn procedure (see page 11-
202).
• Do the power window control unit resetting
procedure (see page 22-200).
• Enter the anti-theft code for the radio and the
navigation system, then enter the customer's
radio station presents.
A
C
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
A
Blower Unit Component
Replacement
Note these items when overhauling the blower unit:
• The recirculation control motor (A), the blower
resistor or power transistor (B) and the blower motor
(C) can be replaced without removing the blower unit.
• Before reassembly, make sure that the recirculation
control linkage and doors move smoothly without
binding.
• After reassembly, make sure the recirculation control
motor runs smoothly (see page 21-39).
A
B
C
21-45
21-45
Advertisement
Chapters
Table of Contents
Troubleshooting
