Shafts And Clutches; Mainshaft Disassembly, Inspection, And Reassembly - Honda 2004 Odyssey Service Manual

Shafts and Clutches

Mainshaft Disassembly, Inspection, and Reassembly

1. Lubricate all parts with ATF during assembly.
NEEDLE BEARINGS
THRUST NEEDLE BEARING
MAINSHAFT
SEALING RINGS,
32 mm
SEALING RING,
29 mm
NEEDLE BEARING
2. Check the clearance of the 4th/5th clutch assembly.
3. Inspect the thrust needle bearing and the needle bearing for galling and rough movement.
4. Inspect the splines for excessive wear and damage.
5. Check shaft bearing surfaces for scoring and excessive wear.
6. Before installing the O-rings, wrap the shaft splines with tape to prevent O-ring damage.
7. Install the conical spring washer and 41 x 73 mm thrust shim in the direction shown.
8. Inspect the condition of the sealing rings. If the sealing rings are worn, distorted, or damaged, replace them (see
page 14-443).
THRUST WASHER,
27 x 47 x 5 mm
THRUST NEEDLE BEARING
4TH GEAR
4TH GEAR COLLAR
Install sealing ring
mating surface as shown.
SET RING
LOCKNUT (FLANGE NUT)
Replace.
226 N·m (23.0 kgf·m, 166 lbf·ft) 0
167 N·m (17.0 kgf·m, 123 lbf·ft)
3RD/4TH CLUTCH ASSEMBLY
O-RINGS
Replace.
THRUST SHIM, 41 x 73 mm
Selective part
THRUST NEEDLE BEARING
4TH GEAR
NEEDLE BEARING
THRUST NEEDLE BEARING
CONICAL SPRING
WASHER
Replace.
IDLER GEAR
TRANSMISSION
HOUSING BEARING
14-441