Honda 2004 Odyssey Service Manual page 693

Automatic Transmission
DTC Troubleshooting (cont'd)
8. Disconnect the 2P connector from shift control
solenoid valve C.
9. Check for continuity between the D3 and B20 or
B22 terminals.
PCM CONNECTORS
B (25P)
LG1 (BRN/BLK)
LG2 (BRN/BLK)
Wire side of female terminals
Is there continuity?
YES Repair short to ground in the wire between
the D3 terminal and the shift control solenoid
valve C.
NO Go to step 10.
10. Measure shift control solenoid valve C resistance at
the solenoid valve connector.
SHIFT CONTROL SOLENOID
VALVE C CONNECTOR
Terminal side of male terminals
Is there 12 25
YES Check for an open in the wires between the
D3 terminal and the shift control solenoid valve C
and between the No. 1 terminal of the shift control
solenoid valve C connector and ground (G101).
NO Replace shift control solenoid valve C (see
page 14-131).
14-80
SH C (GRN)
D (16P)
?
11. Turn the ignition switch ON (II).
12. Measure the voltage between the D5 and B20 or
B22 terminals.
PCM CONNECTORS
B (25P)
LG1 (BRN/BLK)
LG2 (BRN/BLK)
Wire side of female terminals
Is there battery voltage?
YES Check for loose terminal fit in the PCM
connectors. If necessary, substitute a known-good
PCM and recheck.
NO Check for blown No. 6 (15A) fuse in the
driver's under-dash fuse/relay box. If the fuse is OK,
repair open in the wire between the D5 terminal
and the driver's under-dash fuse/relay box.
VB SOL (BLK/YEL)
D (16P)