Honda 2004 Odyssey Service Manual page 1455

Seats
Front Seat Disassembly/Reassembly - Manual Height Adjustable (cont'd)
'03-04 models
• For some models: SRS components are located in this area. Review the SRS component locations (see page 23-20),
and the precautions and procedures (see page 23-21) before performing repairs or service.
• The operation of the driver's seat position sensor must be checked after any of these actions (see page 23-47):
– Driver's seat position sensor replacement
– Cover plate (front side of driver's seat slide rail) replacement
NOTE:
• Route the seat wire harness correctly (see page 20-94).
• Make sure the bushing and pivot washer are installed correctly.
• Apply multipurpose grease to the moving portion of the seat track.
• To prevent wrinkles in the seat-back cover, stretch the material evenly over the pad.
PIVOT NUT
8 x 1.25 mm
22 N·m (2.2 kgf·m, 16 lbf·ft)
SEAT CUSHION
CENTER COVER CENTER COVER
INNER SEAT TRACK
10 x 1.25 mm
47 N·m (4.8 kgf·m,
35 lbf·ft)
SEAT POSITION
SENSOR
SUBHARNESS
SEAT POSITION
SENSOR
20-90
PIVOT WASHER
WIRE TIE
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
16 lbf·ft)
WASHER
WASHER
10 x 1.25 mm
6 x 1.0 mm
47 N·m
9.8 N·m (1.0 kgf·m,
(4.8 kgf·m,
7.2 lbf·ft)
35 lbf·ft)
Use a Torx T30 bit.
CONNECTING WIRE
Twist 90° to connect.
90°
SEAT-BACK
BUSHING
END CAP
CLIP
WASHER
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
16 lbf·ft)
SEAT RISER
HEADREST
SIDE AIRBAG HARNESS
(For some models)
HOOK
HOOKS
HOOKS
10 x 1.25 mm
47 N·m (4.8 kgf·m, 35 lbf·ft)
RECLINE ADJUSTER/
OUTER SEAT TRACK
10 x 1.25 mm
47 N·m (4.8 kgf·m, 35 lbf·ft)
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
END CAP
WASHER
RECLINE
RECLINE
LEVER
COVER
10 x 1.25 mm
47 N·m (4.8 kgf·m, 35 lbf·ft)
HEIGHT
KNOB
CLIP