Fuel Fill Door Switch Replacement - Honda 2004 Odyssey Service Manual

11. Install the motor unit in the reverse order of
removal, and note these items:
• Make sure the connectors are plugged in
properly, and the power sliding door cable is
routed properly.
• After setting the center roller on the center rail,
make sure the sliding door is open fully, and
adjust the tension to the power sliding door
motor unit cable in this sequence:
–1 Turn the adjusting pulley (A) counterclockwise
(left side), or clockwise (right side) until you
can see the front set mark (B) and rear set mark
(C) in the set position windows (D). Be sure
the set mark is within the set position
window area.
–2 If you cannot see the rear set mark, turn the
drum (E) clockwise (left side), or
counterclockwise (right side) gradually until
you can see the rear set mark.
–3 Repeat steps 1 and 2 until the front and rear
set marks are within their windows at the
same time.
–4 After setting the tension, turn on the power
door master switch and operate the sliding
door once with the power sliding door switch.
–5 Turn off the master power door switch and
recheck the positions of the front and rear set
marks. Readjust and test as necessary.
–6 Reseal the quarter plastic cover as necessary.
C
Forward
12. Re-home the power sliding doors (see page 22-291).
D
B
E
A

Fuel Fill Door Switch Replacement

NOTE: Put on gloves to protect your hands.
1. Remove these items:
• Third row seat belt retractor
(see step 3 on page 23-11)
• Quarter plastic cover, as necessary
(see page 20-6)
2. Disconnect the fuel fill door switch connector (A),
release the cable (B) from the cable clip (C), turn the
switch (D) 90°, and remove it.
D
B
3. Install the switch in the reverse order of removal,
and make sure the connector is plugged in properly.
C A
20-21 20-21