Honda 2004 Odyssey Service Manual page 1040

NOTE: Refer to the exploded view as needed during the
following procedure.
1. Remove the ATF feed pipes from the regulator
valve body, servo body, top accumulator body, and
accumulator body.
2. Remove the servo detent base (two bolts).
3. Remove the ATF strainer (two bolts).
4. Remove the top accumulator body (seven bolts),
then remove the accumulator body separator plate
and dowel pins (2).
5. Remove the servo body (five bolts), then remove
servo separator plate and dowel pins (2).
6. Remove the regulator valve body (eight bolts).
7. Remove the stator shaft and stator shaft stop.
8. Remove the regulator separator plate and dowel
pins (2).
9. Remove the accumulator body (seven bolts).
10. Unhook the detent spring from the detent arm, then
remove the detent arm shaft, detent arm, and
control shaft.
11. Remove the cooler check valve spring and cooler
check valve (ball).
12. Remove the main valve body (four bolts).
13. Remove the torque converter check valve and
spring.
14. Remove the ATF pump driven gear shaft, then
remove the ATF pump gears.
15. Remove the main separator plate and dowel pins
(3).
16. Clean the inlet opening (A) of the ATF strainer (B)
thoroughly with compressed air, then check that it
is in good condition and that the inlet opening is
not clogged.
B
A
17. Test the ATF strainer by pouring clean ATF through
the inlet opening, and replace it if it is clogged or
damaged.
14-427