Honda 2004 Odyssey Service Manual page 993

Automatic Transmission
Transmission Installation (cont'd)
8. Install the engine stiffener mounting bolts (A).
C
6 x 1.0 mm
12 N·m (1.2 kgf·m,
8.7 lbf·ft)
D
A
10 x 1.25 mm
38 N·m (3.9 kgf·m, 28 lbf·ft)
9. Attach the torque converter to the drive plate (B)
with eight bolts (C). Rotate the crankshaft pulley as
necessary to tighten the bolts to 1/2 of the specified
torque, then to the final torque, in a crisscross
pattern. After tightening the last bolt, check that the
crankshaft rotates freely.
10. Install the torque converter cover (D).
11. Tighten the crankshaft pulley bolt as necessary (see
page 6-18).
14-380
B
6 x 1.0 mm
12 N·m (1.2 kgf·m,
8.7 lbf·ft)
12. Install new set ring (A) on the intermediate shaft (B).
10 x 1.25 mm
39 N·m (4.0 kgf·m, 29 lbf·ft)
B
13. Clean the areas where the intermediate shaft
contacts the transmission (differential) with solvent
or carburetor cleaner, and dry with compressed air.
Then install the intermediate shaft in the
differential. While installing the intermediate shaft,
be sure not to allow dust or other foreign particles
to enter the transmission.
A