Brake Booster Replacement - Honda 2004 Odyssey Service Manual

Conventional Brake Components

Brake Booster Replacement

1. Remove the master cylinder (see page 19-16).
2. Remove the intake air duct (A) (see step 5 on page
5-3).
C
D
A
3. Remove the cable bracket (B) from the throttle body,
then disconnect the throttle cable end (C) and
actuator cable end (D) from the throttle linkage.
4. Disconnect the vacuum hose (E) from the brake
booster (F).
5. Remove the lock pin (A) and joint pin (B).
B
C
8 x 1.25 mm
25 N·m (2.5 kgf·m, 18 lbf·ft)
6. Remove the 4 brake booster mounting nuts (C).
19-18
B E
F
A
7. Pull the brake booster (A) forward, and remove it
from the engine compartment.
A
8. Install the brake booster in the reverse order of
removal, and note these items:
• After installation, adjust brake pedal height and
brake pedal free play (see page 19-6).
• After installation, check for the cable free play,
and adjust the actuator cable (see page 4-52) and
the throttle cable (see page 11-242) if necessary.