Honda 2004 Odyssey Service Manual page 1072

5. Check the 1st-hold clutch plate-to-top-disc
clearance; starting with a clutch plate, alternately
install the clutch plate and discs in the 1st-hold
clutch drum, then install the 1st-hold clutch plate.
6. Measure the 1st-hold clutch clearance between the
1st-hold clutch plate B and the top disc (A) with a
feeler gauge (C) while pressing the 1st-hold clutch
plate B down. Take measurements in at least three
places, and use the average as the actual clearance.
1st-hold Clutch Plate B-to-Top-disc Clearance
Service Limit: 0.5 0.9 mm (0.020 0.035 in.)
B
7. If the clearance is out of standard, replace the 1st-
hold clutch plates and discs as a set, and recheck.
8. Install the return spring (A) and spring retainer (B),
and position the snap ring (C) on the retainer.
9. Install the special tools on the clutch assembly.
C
07GAE-PG40200 or
A
07GAE-PG4020A
10. Be sure the special tool (A) is adjusted to have full
C
B
A
contact with the spring retainer (B) on the 4th, 5th,
and 1st clutches.
07LAE-PX40100
07LAE-PX40100 or
07HAE-PL50101
A
B
(cont'd)
14-459