End Cover And Idler Gear Installation - Honda 2004 Odyssey Service Manual

Transmission End Cover

End Cover and Idler Gear Installation

Special Tools Required
Mainshaft holder
07GAB-PF50101 or 07GAB-PF50100
1. Install the park lever (A) and park lever stop (B) on
the control shaft (C), then install the lock bolt (D)
with a new lock washer (E). Do not bend the lock
tab of the lock washer until step 25.
C
D
6 x 1.0 mm
14 N·m (1.4 kgf·m, 10 lbf·ft)
2. Lubricate the following parts with ATF:
• Splines of the countershaft, the park gear, and
the old locknut.
• Threads of the countershaft and the old locknut.
• Old conical spring washer.
A
B
E
3. Install the park gear (A) using the old locknut (B)
and a collar (C). Hold the park pawl (D) against the
park gear, then tighten the old locknut until the
shaft splines come out slightly over the park gear
splines.
NOTE:
• Do not use an impact wrench.
• Countershaft locknut has left-hand threads.
B
D
4. Remove the locknut and the collar, then install only
the bearing hub/bearing assembly (A) and old
conical spring washer (B). Tighten the old locknut
(C) to 226 N·m (23.0 kgf·m, 166 lbf·ft), then remove
the locknut and conical spring washer.
NOTE: Use a torque wrench to tighten the locknut.
Do not use an impact wrench.
C
A
C
A
B
(cont'd)
14-231