Honda 2004 Odyssey Service Manual page 974

A/T Clutch Pressure Control Solenoid Valve A and B Replacement
1. Remove the harness cover from the transmission
hanger.
2. Remove the mounting bolts and A/T clutch
pressure control solenoid valves A and B (A).
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
F
D
C
B
E
3. Clean the mounting surface and fluid passages of
A/T clutch pressure control solenoid valves A and B
and the transmission housing.
4. Place a new gasket (B) on the transmission housing,
then install the 8 x 18 mm ATF feed pipes (C) with
their filter sides into the transmission housing.
5. Install new O-rings (D) over the feed pipes, and
install the 8 x 40 mm ATF feed pipe (E).
A
6. Install new A/T clutch pressure control solenoid
valves A and B (A) and harness clamp bracket (F).
7. Check the A/T clutch pressure control solenoid
valve connectors for rust, dirt, or oil, then connect
them securely.
8. Install the harness cover on the transmission
hanger.
14-361