A/T Clutch Pressure Control Solenoid Valve A And B Replacement - Honda 2004 Odyssey Service Manual

A/T Clutch Pressure Control Solenoid Valve A and B Replacement

1. Remove the ATF cooler hose (outlet line) at the ATF
cooler line. Turn the end of the cooler hose up to
prevent ATF from flowing out, then plug the line
and hose.
2. Remove the bolt securing the harness cover, then
remove the harness cover from the transmission
hanger.
3. Remove the ATF cooler line (outlet line) from the
transmission housing.
4. Remove the mounting bolts and the A/T clutch
pressure control solenoid valves A and B (A).
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7lbf·ft)
H
G
E
B
5. Clean the mounting surface and fluid passages of
6. Place a new gasket (B) on the transmission housing,
7. Install new O-rings (F) over the feed pipes, and
8. Install the new A/T clutch pressure control solenoid
A
9. Check the A/T clutch pressure control solenoid
10. Install the ATF cooler outlet line, and connect the
F
C
D
the A/T clutch pressure control solenoid valves A
and B and the transmission housing.
then install the 8 x 18 mm ATF feed pipe (C),
8 x 26 mm pipe (D), and 8 x 36 mm pipe (E) with
their filter side into the transmission housing.
install the 8 x 40 mm ATF feed pipe (G).
valves A and B (A) and harness clamp bracket (H).
valve connectors for rust, dirt, or oil then connect
them securely.
ATF cooler hose to the cooler line.
14-133