Honda 2004 Odyssey Service Manual page 704

8. Disconnect the 3P connector from the lock-up
control solenoid valve/shift control solenoid valve
A assembly.
9. Check for continuity between the D1 and B20 or
B22 terminals.
PCM CONNECTORS
B (25P)
LG1 (BRN/BLK) LG2 (BRN/BLK)
Wire side of female terminals
Is there continuity?
YES Repair short to ground in the wire between
the D1 terminal and the lock-up control solenoid
valve.
NO Go to step 10.
10. Measure the resistance between the No. 3 terminal
of the lock-up control solenoid valve/shift control
solenoid valve A assembly connector and body
ground.
LOCK-UP CONTROL SOLENOID VALVE/
SHIFT CONTROL SOLENOID VALVE A
ASSEMBLY CONNECTOR (3P)
Terminal side of male terminals
Is the resistance 12 25 ?
YES Check for an open in the wire between the D1
terminal and the lock-up control solenoid valve.
NO Replace the lock-up control solenoid valve/
shift control solenoid valve A assembly (see page
14-130).
LC (YEL)
D (16P)
LC (BLU/YEL)
11. Turn the ignition switch ON (II).
12. Measure the voltage between the D5 and B20 or
B22 terminals.
PCM CONNECTORS
VB SOL (BLK/YEL)
B (25P)
LG1 (BRN/BLK)
LG2 (BRN/BLK)
Wire side of female terminals
Is there battery voltage?
YES Check for loose terminal fit in the PCM
connectors. If necessary, substitute a known-good
PCM and recheck.
NO Check for blown No. 6 (15A) fuse in the
driver's under-dash fuse/relay box. If the fuse is OK,
repair open in the wire between the D5 terminal
and the driver's under-dash fuse/relay box.
D (16P)
14-91