Honda 2004 Odyssey Service Manual page 976

A/T Clutch Pressure Control Solenoid Valve C Replacement
1. Disconnect the connector from A/T clutch pressure
control solenoid valve C.
2. Remove A/T clutch pressure control solenoid valve
C (A).
C
A
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
3. Clean the mounting surface and fluid passage of
A/T clutch pressure control solenoid valve C and
the transmission housing.
4. Install the 8 x 12 mm ATF feed pipe (B) with its filter
side into the transmission housing.
5. Install the new gasket (C) in the mounting groove of
A/T clutch pressure control solenoid valve C body
properly, then install them on transmission
housing. Do not pinch the gasket.
6. Check the solenoid connector for rust, dirt, or oil,
and connect it securely.
B
14-363