4Th/5Th Clutch Clearance Inspection - Honda 2004 Odyssey Service Manual

Shafts and Clutches

4th/5th Clutch Clearance Inspection

1. Remove the O-rings from the mainshaft.
2. Assemble the 41 x 73 mm thrust shim (A), 4th/5th
clutch assembly (B), and 5th gear collar (C) on the
mainshaft (D).
14-442
C
B
A
D
3. Hold the 5th gear collar (C) against the clutch
assembly (B), then measure the clearance between
the clutch guide (E) and the 5th gear collar with a
feeler gauge (F) in at least 3 places. Use the
average as the actual clearance.
Standard: 0.03 0.11 mm (0.001 0.004 in.)
A
B
4. If the clearance is out of standard, remove the
thrust shim and measure its thickness.
5. Select and install a new shim, then recheck.
THRUST SHIM, 41 x 73 mm
No. Part Number
1 90414-P7W-000
2 90415-P7W-000
3 90416-P7W-000
4 90417-P7W-000
5 90418-P7W-000
6 90419-P7W-000
6. After replacing the thrust shim, make sure the
clearance is within standard.
C
F
E
C
F
Thickness
7.85 mm (0.309 in.)
7.90 mm (0.311 in.)
7.95 mm (0.313 in.)
8.00 mm (0.315 in.)
8.05 mm (0.317 in.)
8.10 mm (0.319 in.)