Honda 2004 Odyssey Service Manual page 973

Automatic Transmission
A/T Clutch Pressure Control Solenoid Valve A and B Test
1. Disconnect the 2P connectors from the A/T clutch
pressure control solenoid valves A (A) and B (B).
A
2. Measure the A/T clutch pressure control solenoid
valves A and B resistances at each solenoid valve
connector.
Standard: 3 10
3. If the resistance of either solenoid is out of
standard, replace A/T clutch pressure control
solenoid valves A and B.
4. Connect the No. 1 terminal of A/T clutch pressure
control solenoid valves A and B to the battery
positive terminal, and connect the No. 2 terminal to
the battery negative terminal. A clicking sound
should be heard. Remove A/T clutch pressure
control solenoid valves A and B, if no sound is
heard.
5. Check the fluid passage of the A/T clutch pressure
control solenoid valves for dust and dirt, and clean
the passage if necessary.
14-360
6. Connect the No. 1 terminal of A/T clutch pressure
B
7. Disconnect one of the battery terminals and check
8. If either valve binds, or moves sluggishly, or if the
control solenoid valves A and B to the battery
positive terminal, and connect the No. 2 terminal to
the battery negative terminal. Make sure the A/T
clutch pressure control solenoid valves A and B
move.
A
valve movement.
NOTE: You can see the valve movement through
the fluid passage in the mounting surface of the
solenoid valve body (C).
solenoid does not operate, replace the A/T clutch
pressure control solenoid valves A and B.
C
B