Maximum-Paths; Trapflags - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual
Layer-3 stackable switches, software version 7.3
Hide thumbs
Also See for GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch:
- Cli manual (787 pages) ,
- Hardware installation manual (42 pages) ,
- Administration manual (561 pages)
Table of Contents
Advertisement
Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
14.5.37.1 no redistribute
This command configures OSPF protocol to prohibit redistribution of routes from the
specified source protocol/routers.
Format
Mode
14.5.38 maximum-paths
This command sets the number of paths that OSPF can report for a given destination
where
maxpaths
Default
Format
Mode
14.5.38.1 no maximum-paths
This command resets the number of paths that OSPF can report for a given destination
back to its default value.
Format
Mode
14.5.39 trapflags
This command enables OSPF traps.
Default
Format
Mode
14.5.39.1 no trapflags
This command disables OSPF traps.
Format
Mode
Routing Commands
no redistribute {rip | static | connected} [met-
ric] [metric-type] [tag] [subnets]
Router OSPF Config
is platform dependent.
4
maximum-paths <maxpaths>
Router OSPF Config
no maximum-paths
Router OSPF Config
enabled
trapflags
Router OSPF Config
no trapflags
Router OSPF Config
v4.1, October 2008
14-41
Advertisement
Chapters
Table of Contents
