Finding The Physical Chassis For A Logical Switch; Finding The Logical Switch From A Physical Chassis - Brocade Communications Systems StoreFabric SN6500B User Manual

19
Configuring Virtual Fabrics
6. Click the Switch tab and enter switch parameters.
7.
The newly created logical switch has no ports. To assign ports to the logical switch, refer to
"Assigning ports to a logical switch"
If the newly created logical switch is not part of a discovered fabric, then you must undiscover and
rediscover the switch.
•
•
When entering the IP address, use the IP address of the physical fabric.

Finding the physical chassis for a logical switch

The Management application enables you to locate the physical chassis in the Product List from
which the logical switch was created.
To find the physical chassis for a logical switch, right-click the logical switch in the Connectivity Map
or Product List and select Virtual Fabric > Chassis.
The physical chassis is highlighted in the Product List.

Finding the logical switch from a physical chassis

The Management application enables you to locate the logical switch from the physical chassis.
1. Expand the Chassis Group node in the Product List.
2. Right-click the physical chassis within the Chassis Group.
3. Select Virtual Fabric > Logical Switches > Logical_Switch_Name.
The logical switch you selected is highlighted in the Product List and Connectivity Map.
518
e. (Optional) For Backbone Chassis only, select an option in the 256 Area Limit list to use
256-area addressing mode (zero-based or port-based) or to disable this mode (default).
The 256-area addressing mode can be used in FICON environments, which have strict
requirements for 8-bit area FC addresses.
a. Enter a name for the logical switch in the Name field.
b. Select a domain ID in the Preferred Domain ID list.
In a FICON environment, select a domain ID that is not in use by the default or another
logical switch in the same chassis.
c. (Optional) Select the Insistent check box to not allow the domain ID to be changed when a
duplicate domain ID exists.
If you select this check box and a duplicate domain ID exists, the switch will segment from
the fabric instead of changing the domain ID.
Click OK on the New Logical Switch dialog box.
The new logical switch displays in the Existing Logical Switches list (already highlighted). This
logical switch has no ports.
To undiscover the physical chassis, refer to
To rediscover the physical chassis, refer to
on page 519.
"Deleting a fabric"
"Discovering fabrics"
Brocade Network Advisor SAN User Manual
on page 48 for instructions.
on page 41 for instructions.
53-1002696-01