Configuring An Fcip Tunnel - Brocade Communications Systems StoreFabric SN6500B User Manual

22

Configuring an FCIP tunnel

Configuring an FCIP tunnel
When you configure an FCIP extension connection, you create FCIP tunnels and FCIP circuits,
between two extension switches.
1. Select Configure > FCIP Tunnels.
FIGURE 346
2. To add an FCIP tunnel and circuits between switches follow these steps:
776
The FCIP Tunnels dialog box is displayed
switches are listed under devices.
FCIP Tunnels dialog box (fabric selected from Product tree)
a. Select the switch you want to configure under the Products tree.
b. Click the Add button, or right-click on the switch and select Add Tunnel.
The Add FCIP Tunnel dialog is displayed
is displayed in the Switch field under Switch One Settings. This dialog allows you to
configure settings for both switches on either end of the tunnel.
A Circuits properties table displays at the bottom of the dialog box. For 8 Gbps platforms,
this may contain columns for multiple circuits. Actual, as well as cached circuits display.
You can configure circuits using the Add, Edit, Delete, Enable, and Disable circuits using
the function buttons to the right of the table. For 4 Gbps platforms, the Delete, Enable, and
Disable buttons do not display. In addition, the Edit operation is only supported for cached
circuits.
(Figure 346). All discovered fabrics with extension
(Figure 347). The name of the switch you selected
Brocade Network Advisor SAN User Manual
53-1002696-01