Adding Members To A Traffic Isolation Zone - Brocade Communications Systems StoreFabric SN6500B User Manual

3. Select a fabric from the Zoning Scope list.
4. Select Domain, Port Index from the Type list.
5. Select New TI Zone from the New Zone list.
6. Enter a name for the zone.
7.
8. Click OK or Apply to save your changes.

Adding members to a Traffic Isolation zone

NOTE
Traffic Isolation zones are configurable only on a Fabric OS device.
Use this procedure to add a member to a zone when the member is listed in the Potential Members
list of the Zone DB tab. Only ports can be added as members to a Traffic Isolation zone. You must
add two or more N_Ports as well as all E_Ports on the path between the N_Ports.
NOTE
You cannot add a device as a member to a Traffic Isolation zone.
1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select a fabric from the Zoning Scope list.
4. (Optional) If you want to show all discovered fabrics in the Potential Members list, right-click in
5. Select one or more Traffic Isolation zones to which you want to add members in the Zones list.
6. Select Domain, Port Index from the Type list.
7.
Brocade Network Advisor SAN User Manual
53-1002696-01
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
For zone name requirements and limitations, refer to
Press Enter.
The Traffic Isolation zone is saved, but is not activated.
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
the Potential Members list and select Display All.
(Press SHIFT or CTRL and click each zone name to select more than one zone.)
Select two or more N_Ports (as well as all E_Ports on the path between the N_Ports) to add to
the zone in the Potential Members list. (Press SHIFT or CTRL and click each port to select more
than one port.)
NOTE
TI zones can be created in fabrics that contain logical switches; however, you can only select
physical ports for TI zones.
If you select a trunk port to add to the TI zone, all trunk ports in the trunk group are added to
the TI zone automatically.
Traffic Isolation zones
"Zone naming conventions"
21
on page 716.
745