Brocade Communications Systems StoreFabric SN6500B User Manual page 690

20
Configuring encryption storage targets
FIGURE 286
5. Select the encryption engine (blade or switch) to configure, then click Next.
642
Select Encryption Engine dialog box
The dialog box contains the following information:
•
Encryption engine: The name of the encryption engine. The list of engines depends on the
scope being viewed:
•
If an encryption group was selected, the list includes all engines in the group.
•
If a switch was selected, the list includes all encryption engines for the switch.
•
If a single encryption engine was selected, the list contains only that engine.
•
Fabric Name: The name of the fabric to which the selected encryption engine (blade or
switch) is configured.
•
Engine Media Type: The media type of the encryption engine. Options are: Tape and Disk.
The Select Target dialog box displays
target nodes in the same fabric as the encryption engine. The Targets in Fabric table does not
show targets that are already configured in an encryption group.
(Figure 287). The dialog box lists all target ports and
Brocade Network Advisor SAN User Manual
53-1002696-01