Viewing time left for auto rekey
You can view the time remaining until auto rekey is no longer active for a disk LUN. The information
is expressed as the difference between the next rekey date and the current date and time, and is
measured in days, hours, and minutes.
Although you cannot make changes directly to the table, you can modify the time left using CLI. For
more information, see the administrator's guide supporting your key vault management system.
To view the time left for auto rekey, follow these steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
2. Select a group, switch, or engine from the Encryption Center Devices table for which to view the
3. Select a target disk device from the table, then click LUNs.
FIGURE 325
Brocade Network Advisor SAN User Manual
53-1002696-01
dialog box. (Refer to
Figure 185
auto rekey information, then select Group/Switch/Engine > Targets from the menu task bar.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays. (Refer to
The Encryption Target Disk LUNs dialog box displays. The time left for auto rekey information is
listed in the table
(Figure
Encryption Targets Disk LUNs dialog box - Time left for auto rekey
on page 526.)
325).
Viewing time left for auto rekey
Figure
293.)
20
691