Deleting A Port Group; Swapping Blades - Brocade Communications Systems StoreFabric SN6500B User Manual

7.
8. Click the left arrow button.
9. Click Update.
10. Click OK.

Deleting a port group

To delete a port group, complete the following steps.
1. Select Configure > Port Groups.
2. Select the port group you want to delete in the Port Groups table.
3. Click Remove.
4. Click OK.

Swapping blades

NOTE
Blade-based port swap is mainly used for FICON and is only applicable for port blades. However, the
Management application does not block blade-based port swap for other application blades,
including the 8 Gbps 24-port blade.
You can swap all of the ports from one blade to another blade. During this operation all ports in the
selected blades are swapped. This operation disrupts the traffic on all ports for the selected
blades. If GigE ports are present on the blade, only the non-GigE ports are swapped.
To swap blades, you must meet the following requirements:
•
•
•
Example
The source blade has ports sp1 and sp2, and the destination blade has ports dp1 and dp2. During
the swap operation, the address sp1 is swapped with dp1 and address sp2 is swapped with dp2.
NOTE
To perform the Swap Blades function you must have Read and Write access for the Product
Administration privilege.
To swap blades, complete the following steps.
Brocade Network Advisor SAN User Manual
53-1002696-01
Select one or more ports to remove from the group in the Membership List table.
The selected ports are removed from the Membership List.
The Port Groups dialog box displays.
The selected ports are removed from the Port Groups table.
The chassis must be running Fabric OS 6.3 or later.
You must have read and write access for the Product Administration privilege.
The chassis must have at least two blades of same type present.
25

Swapping blades

851