Brocade Communications Systems StoreFabric SN6500B User Manual page 691

FIGURE 287
6. Select a target from the list. (The Target Port WWN and Target Node WWN fields contain all
7.
Brocade Network Advisor SAN User Manual
53-1002696-01
Select Target dialog box
The dialog box contains the following information:
•
Target Port WWN: The world wide name of the target port in the same fabric as the
encryption engine.
•
Target Port Name: The name of the target port in the same fabric as the encryption engine.
•
Target Node WWN: The world wide name of the target node in the same fabric as the
encryption engine.
•
Target Node Name: The name of the target device.
•
Targets list: Options are: Tape and Disk.
NOTE
The Targets list does not show targets that are already configured in the encryption group.
target information that displays when using the nsShow command.) You can also enter WWNs
manually, for example, to specify a target that is not on the list.
Select a target type from the Type list, then click Next.
The Select Hosts dialog box displays
device ports. All hosts that are in the same fabric as the encryption engine are listed.
NOTE
The selected target and initiator port must be in the same zone, or an error will result.
Configuring encryption storage targets
(Figure 288). You can configure hosts for selected target
20
643