22
Configuring FCIP tunnel advanced settings
3. Click OK to commit your selection.
For the 8 Gbps Extension Switch and 8 Gbps Extension Blade:
1. Select Advanced Settings on the Add FCIP Tunnel or Edit FCIP Tunnel dialog box to display the
2. From the Transmission tab, select the Enable Compression check box to enable compression.
3. Select the desired compression mode.
4. Click OK to commit you selection.
To disable compression, click the Enable Compression to clear the check mark, and click OK.
782
Advanced Settings dialog box.
This enables the Compression Mode selector
FIGURE 350
Selecting a compression mode
A Standard option provides hardware compression and is available on all platforms. The 8
Gbps Extension Switch and the 8 Gbps Extension Blade provide three additional options for
compression. The Moderate option enables a combination of hardware and software
compression that provides more compression that hardware compression alone. This option
supports up to 8 Gbps of FC traffic. the Aggressive option is a software only compression
option that provides a more aggressive algorithm. This option supports up to 2.5 Gbps of FC
traffic. The Auto option allows the system to set the best compression mode based on the
tunnel's configured bandwidth and the bandwidth of all tunnels in the system.
(Figure
350).
Brocade Network Advisor SAN User Manual
53-1002696-01