22
Adding an FCIP circuit
4. To add a circuit, click Add to the right of the Circuits properties table at the bottom of the dialog
Adding an FCIP circuit
When adding a new FCIP tunnel, you can add an FCIP circuit by selecting the Add button to the right
of the Circuits properties table on the Add FCIP Tunnel dialog box
Gbps platforms, you can add multiple FCIP circuits to the tunnel with this button.
Add circuits to existing FCIP tunnels through the Edit FCIP Tunnel dialog box. To display this dialog
box, right-click a tunnel on the FCIP Tunnels dialog box and select Edit Tunnel or select a tunnel and
click the Edit button. For details, refer to
NOTE
The 4 Gbps Router, Extension Switch, and blade support only one circuit.
FIGURE 348
778
A Circuits properties table displays at the bottom of the dialog box. For 8 Gbps platforms,
this may contain columns for multiple circuits. Actual, as well as cached circuits display.
You can configure circuits using the Add, Edit, Delete, Enable, and Disable circuits using
the function buttons to the right of the table. For 4 Gbps platforms, the Delete, Enable, and
Disable buttons do not display. In addition, the Edit operation is only supported for cached
circuits.
c.
Change configuration settings as required using the following steps.
box.
The Add FCIP Circuit dialog is displayed. Continue with
Add FCIP Circuit dialog box
"Adding an FCIP
(Figure 347
"Configuring an FCIP tunnel"
Brocade Network Advisor SAN User Manual
circuit".
on page 777). For 8
on page 776.
53-1002696-01