Managing Ip Addresses On An Svi - Brocade Communications Systems StoreFabric SN6500B User Manual

26
VLAN routing

Managing IP addresses on an SVI

Switch Virtual Interfaces (SVIs) can be added to port VLANs when you create or modify VLAN
definitions. SVIs can only be created in Layer 3 products.
Once VLAN definitions are deployed to products, you can add an IP address to the SVI by
completing the following steps.
1. On the VLAN Manager dialog box, complete one of the following tasks:
2. Click the IP button.
3. Complete one of the following steps:
872
-
Click the VLAN View tab and expand the VLAN node. Select the product that contains the
SVI that you want to define. The list of interfaces appears in the interface list. Click the SVI
in the list of interfaces to select it.
-
On the Product View tab, expand the product or group folders. Expand the products under
the folder and select the VLAN that contains an SVI. The list of interfaces appears in the
interface list. Click the SVI in the list of interfaces to select it.
NOTE
For DCB products, you must select the port VLAN itself to enable the IP button.
The Virtual Port - IP Configuration dialog box displays, as shown in
have been configured for the SVI, they are listed in the Selected IP Addresses list.
FIGURE 389
Virtual Port - IP Configuration dialog box
-
To add a new IP address to the SVI, enter the IP address in the IP Address field and click
the right arrow button to move it to the Selected IP Addresses list.
-
To modify an IP address of an SVI, select the IP address from the list and click the left
arrow button to move the IP address back to the IP Parameters list. Because this list is for
a single IP address, multiple IP addresses cannot be edited.
-
To remove an IP address from the Selected IP Addresses list, select the IP address and
click the left arrow button.
Figure 389. If IP addresses
Brocade Network Advisor SAN User Manual
53-1002696-01