•
•
•
•
•
•
•
Adding a trap recipient to one or more switches
The SNMP Trap Recipients dialog box allows you to register any recipient as a trap recipient on
selected products. You can register different recipients for different products.
NOTE
You can register and unregister other recipient servers on the Fabric OS switches on a per-switch
basis. For IP products, you can perform registration only at the switch level.
1. Select Monitor > SNMP Setup > Product Trap Recipients.
2. Click Add from the Action list.
3. Enter the IP address of the SNMP trap receiver (the recipient server) in the Recipient IP
4. Enter the SNMP trap port of the recipient in the Recipient Port field. This is a mandatory field.
Brocade Network Advisor SAN User Manual
53-1002696-01
"Adding an SNMP v3 credential"
"Adding an SNMP v1 or v2c community string"
"Importing a new MIB into the Management application"
"Trap customization"
"Unregistering a registered trap"
"Customizing a registered trap definition"
"Reverting the customization of a registered trap to default"
The SNMP Trap Recipients dialog box, shown in
FIGURE 421
SNMP Trap Recipients dialog box
Address field. This is a mandatory field. IPv4 addresses are accepted, but a Domain Name
System (DNS) name is not accepted.
Valid numeric values range from 1 through 65535 and 162 is the default.
SNMP traps
Figure
421, displays.
32
979