Circuit Configuration Failure; Configuring Fcip Tunnel Advanced Settings; Enabling And Disabling Compression - Brocade Communications Systems StoreFabric SN6500B User Manual

12. Click Apply on the Add FCIP Circuit dialog box to add the circuit and leave the dialog box open
13. Click OK to close the Add FCIP Tunnel dialog box.

Circuit configuration failure

When a tunnel cannot be created because the process for adding a new circuit configuration fails,
a FCIP Tunnel/Circuit Configurations dialog box displays. Using this dialog box, you can perform the
following tasks:
•
•
•
•

Configuring FCIP tunnel advanced settings

Compression, FCIP fast write and tape pipelining, IPSec and IKE policies, and FICON emulation
features are configured as advanced settings.
1. Click Advanced Settings on the Add FCIP Tunnel or Edit FCIP Tunnel dialog box.
2. Click OK to close Advanced Settings when you have configured the features that you want to
3. Click OK to close the Add FCIP Tunnel dialog box.

Enabling and disabling compression

Data compression can improve performance on long distance connections. The procedure for
enabling compression for the 4 Gbps Extension Switch and Blade is different than the procedure
for enabling compression for the 8 Gbps Extension Switch and Extension Blade.
For 4 Gbps Extension Switch and Blade:
1. Select Advanced Settings on the Add FCIP Tunnel or Edit FCIP Tunnel dialog box to display the
2. From the Transmission tab, select the Enable Compression check box to enable compression.
Brocade Network Advisor SAN User Manual
53-1002696-01
-
Use the Max. Retransmits option to override the default value of 8. As shown, the range is
1 to 8.
-
Select L2CoS and DSCP priorities. Refer to
information.
-
Select OK to save the settings and close the dialog box.
to add additional circuits. Click OK to add the circuit and close the dialog box.
Roll back the current changes to the circuit configuration.
Elect to not roll back current circuit configuration changes.
Continue configuring additional circuits at this point.
Stop configuring additional circuits.
The Advanced Settings dialog box is displayed. This dialog box has a Transmission tab, Security
tab, and FICON Emulation tab.
implement.
Advanced Settings dialog box.
Configuring FCIP tunnel advanced settings
"QOS, DSCP, and VLANs"
22
on page 770 for more
781