32
SNMP traps
Adding an SNMP v3 credential
The SNMP v3 Credentials dialog box allows you to add the SNMP v3 credentials. To add an SNMP
v3 credential, complete the following steps.
1. Select Monitor > SNMP Setup > Event Reception.
2. Select an SNMP v3 credential from the SNMP v3 Credentials list on the Event Reception dialog
3. Click Add.
4. Type the user name in the User Name field.
5. Select an authentication protocol from the Auth Protocol list. You can select -None-,
6. Type a password in the Auth Password field and re-type the password in the Auth Confirm
7.
8. Type a password in the Priv Password field and re-type the password in the Confirm Priv
9. Click OK.
986
The Event Reception dialog box displays.
box.
The Add SNMP v3 Credentials dialog box, shown in
FIGURE 426
Add SNMP v3 Credentials dialog box
For configurations that do not have authentication or privacy, the Management application
uses the user name to match for authentication.
HMAC-MD5, or HMAC_SHA. HMAC_MD5 is the default.
If you select no authentication, the Management application uses the user name to match for
authentication.
Password field.
Select a privacy protocol from the Priv Protocol list. You can select -None-, CBC_DES, or
CFB_AES_128.
If you select no privacy, the Management application uses the user name to match for
authentication.
Password field.
Figure
426, displays.
Brocade Network Advisor SAN User Manual
53-1002696-01