Editing A Dcb Switch - Brocade Communications Systems StoreFabric SN6500B User Manual

5. Select at least one available DCB port from the Available Members list and click the right arrow
6. Continue to configure the following LAG parameters. These parameters are always enabled.
7.
8. Click OK after changing the attributes of the current deployment.
9. Click Start on the Deployment Status dialog box to save the changes to the selected LAG or
10. Click Close to close the Deployment Status dialog box.

Editing a DCB switch

1. Select Configure > DCB.
2. Select the DCB switch from the Products/Ports list.
3. Click Edit.
Brocade Network Advisor SAN User Manual
53-1002696-01
button to move it to the LAG Members list.
The DCB ports are now part of the link aggregation group.
•
Type - Sets the limit on the size of the LAG. The type values include Standard, where the
LAG is limited to 16 ports, and Brocade LAG, where the LAG is limited to 4 ports. The
default is Standard.
You cannot create Fabric OS-type LAGs from different anvil chips. If you do, an error
message displays. Only the first port is considered as part of the LAG.
•
Mode - Sets all ports added to the LAG members table in either Static or Dynamic mode.
The default is Dynamic, Active, but LAG members can be Active or Passive if the LAG
member is Dynamic.
When you have finished configuring the policies, click OK.
The Deploy to LAGs dialog box displays.
The Deployment Status dialog box launches.
LAGs.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
The Edit Switch dialog box displays (Figure 154).
16
DCB Configuration
449