Creating a DCB map to carry the LAN and SAN traffic
To create a DCB map to carry the LAN and SAN traffic, complete the following steps.
NOTE
This procedure is applicable for Fabric OS versions earlier than Fabric OS 7.0. For Fabric OS versions
7.0 and later, you can only edit the the default DCB map.
1. Select Configure > DCB.
2. Select the switch to edit from the Products/Ports list and click Edit.
3. Click the QoS tab.
4. Select DCB from the Map Type list.
5. Configure the following DCB Map parameters in the DCB Map area:
Brocade Network Advisor SAN User Manual
53-1002696-01
The DCB Configuration dialog box displays.
The Edit Switch dialog box displays.
The Edit Switch dialog box - QoS tab displays, as shown in
FIGURE 151
Edit Switch dialog box - QoS tab
•
Name - Enter a name to identify the DCB map.
•
Precedence - Enter a value between 1 through 100. This number determines the map's
priority.
•
Priority Flow Control check box - Check to enable priority-based flow control on individual
priority groups.
DCB Configuration
Figure
151.
16
443