Fcip Troubleshooting; Configuring Ip Ping - Brocade Communications Systems StoreFabric SN6500B User Manual

28

FCIP troubleshooting

7.
FCIP troubleshooting
NOTE
FCIP troubleshooting is only available for Fabric OS devices.
You can perform the following operations using FCIP troubleshooting:
•
•
•

Configuring IP ping

NOTE
IP Ping only supported on Fabric OS devices running Fabric OS 5.2 or later.
NOTE
IP Perf is not supported on the Fabric OS 8 Gbps Extension Switch or Blade.
You can also verify IP connectivity when configuring an FCIP circuit. For more information, refer to
"Adding an FCIP
To configure IP ping, complete the following steps.
1. Select Configure > FCIP > Troubleshooting > Ping.
2. Select a switch from the Available Switches table.
3. Select a port from the GigE Port list.
4. Select an IP address switch from the IP Interface list.
5. Enter the remote IP address in the Remote IP Address field.
6. Click OK.
890
Click OK on the Link Traffic Test Configuration dialog box.
The Diagnostic Port Test dialog box displays. Return to
diagnostics" on page 885.
Ping. Use to confirm that the configured FCIP tunnels are working correctly.
Trace Route. Use to view the route information from a source port on the local device to a
destination port on another device and determine where connectivity is broken.
Performance. Select to view FCIP tunnel performance between two devices.
circuit".
The IP Ping dialog box displays.
Ping sends four Internet Control Message Protocol (ICMP) Ping packets to the destination
address and records the time until a response.
The IP Ping Result dialog box displays with two tables.
The top table (FCIP IP Ping Response Details) contains the following statistics:
step 5 of "Troubleshooting port
Brocade Network Advisor SAN User Manual
53-1002696-01