Deleting An Allow/Prohibit Matrix Configuration; Changing The Allow/Prohibit Matrix Display; Changing Window Arrangement - Brocade Communications Systems StoreFabric SN6500B User Manual

Deleting an Allow/Prohibit Matrix configuration

NOTE
If you receive a 'FICON not supported on switch' error, refer to FICON troubleshooting for a list of
possible causes.
You cannot delete the active configuration, the IPL configuration, or a configuration that is marked
as having uncommitted changes.
1. Select Configure > Allow/Prohibit Matrix.
2. Select the Allow/Prohibit Matrix configuration you want to delete. You can do this by expanding
3. Click Delete.
4. Click Yes to confirm.

Changing the Allow/Prohibit Matrix display

You can modify the display using the Window Arrangement list above the matrix display or the Clear
all port names option below the display.
NOTE
If you receive a 'FICON not supported on switch' error, refer to FICON troubleshooting for a list of
possible causes.

Changing window arrangement

There are three options for the Allow/Prohibit Matrix display on the Configure Allow/Prohibit Matrix
dialog box located in the Window Arrangement list above the display.
•
•
•
Perform the following steps to change the display to the desired format.
1. Select Configure > Allow/Prohibit Matrix.
2. Select Cascade, Tile Horizontally, or Tile Vertically from the Window Arrangement list.
Brocade Network Advisor SAN User Manual
53-1002696-01
The Configure Allow/Prohibit Matrix dialog box displays.
the view for the switch under Available Switches and selecting a configuration, or you may
select the matrix under Allow/Prohibit Matrix.
A confirmation message displays.
The matrix definitions may be cascaded (this is the default view).
The matrix definitions may be tiled horizontally.
The matrix definitions may be tiled vertically.
The Configure Allow/Prohibit Matrix dialog box displays.

Deleting an Allow/Prohibit Matrix configuration

25
839