Editing A State Change Threshold - Brocade Communications Systems StoreFabric SN6500B User Manual

24
Editing thresholds
3. Select the threshold you want to change and click Edit.
4. Complete
5. Click OK on the Edit Protocol Error Threshold dialog box.
6. Click OK on the Port Fencing dialog box.

Editing a State Change threshold

NOTE
This threshold is only available for Fabric OS devices running 6.3 or later.
NOTE
This feature requires a Trial or Licensed version.
Use to block a port when a state change violation type meets the Fabric OS switch threshold. For
4 Gbps Router, Extension Switches and Blades only, when you apply this threshold on an E Port, the
threshold is also applied to the VE Ports (internally by Fabric OS).
To edit an State Change threshold, complete the following steps.
1. Select Monitor > Fabric Watch > Port Fencing.
2. Select State Change (Fabric OS only) from the Violation Type list.
3. Select the threshold you want to change and click Edit.
4. Complete
5. Click OK to add the state change threshold to the table and close the Edit State Change
6. Click OK on the Port Fencing dialog box.
826
The Edit Protocol Error Threshold dialog box displays.
step 4 through step 5
If the threshold has already been assigned to ports, an "Are you sure you want to make the
requested changes to this threshold on "X" ports?" message displays. Click OK to close.
To assign this threshold to fabrics, switches, or switch ports, refer to
page 821.
The Port Fencing dialog box displays.
The Edit State Change Threshold dialog box displays.
step 4 through step 7
Threshold dialog box.
To assign this threshold to fabrics, switches, or switch ports, refer to
page 821.
in "Adding a Protocol Error threshold"
in "Adding a State Change threshold"
Brocade Network Advisor SAN User Manual
on page 818.
"Assigning thresholds" on
on page 820.
"Assigning thresholds" on
53-1002696-01