Configuring Ipsec And Ike Policies - Brocade Communications Systems StoreFabric SN6500B User Manual

22
Configuring FCIP tunnel advanced settings

Configuring IPSec and IKE policies

IPSec and IKE policies are configured from the Security tab. The screens and procedures are
platform-dependent.
and 8 Gbps Extension Blade.
1. Select Advanced Settings on the Add FCIP Tunnel or Edit FCIP Tunnel dialog box to display the
2. Select the Security tab.
3. As an option, click Ensure connecting peer switches have known WWNs. This provides an
4. Enter the WWN for the remote switch.
5. Assign IKE and IPsec policies. For the 4 Gbps Extension Switch and Blade, you must choose
6. In the PreShared Key field, specify the key for IKE authentication. Use the following
784
Figure 351
Advanced Settings dialog box.
FIGURE 351
Advanced Settings Security Tab for the 8 Gbps extension Switch and Blade
added measure of security.
from a drop-down list of policies. The 8 Gbps Extension Switch and Blade have predefined IKE
and IPsec policies. These policies are enabled by selecting the Enable IPSec check box.
Matching policies are applied to the remote switch. Note that the Enable IPSec check box is
grayed while editing the tunnels because the IPsec settings cannot be edited for the secured
tunnels.
NOTE
IPSec settings cannot be edited. If you want to change settings, you will need to delete the
tunnel and then create a new tunnel with the new settings.
specifications, depending on your extension platform.
on page 784 shows the screen for the 8 Gbps Extension Switch
Brocade Network Advisor SAN User Manual
53-1002696-01