Host Performance Management - Brocade Communications Systems StoreFabric SN6500B User Manual

15

Host performance management

Host performance management

Real-time performance enables you to collect data from managed HBA and CNA ports. You can use
real-time performance to configure the following options:
•
•
•
NOTE
In the Port Picker dialog box, the Brocade 1860 Fabric Adapter in AnyIO mode displays in both
categories (HBA port measures and CNA port measures). The ports are properly filtered to display
only the CNA or HBA port based on the selection.
Table 58
TABLE 58
FC port measures
Tx % utilization
Rx % utilization
Tx MBps
Rx MBps
CRC errors
Signal losses
Sync losses
Link failures
Sequence errors
Invalid transmissions
Rx link resets
Tx link resets
428
Select the polling rate from 20 seconds up to 1 minute.
Select up to 32 ports total from a maximum of 10 devices for graphing performance.
Choose to display the same Y-axis range for both the Tx MBps and Rx MBps measure types for
easier comparison of graphs.
lists the counters that are supported for the FC ports and for the HBA and CNA ports.
Counters
HBA port measures
Tx % utilization
Rx % utilization
Tx MBps
Rx MBps
CRC errors
Signal losses
Sync losses
Link failures
Primitive sequence protocol errors
NOS count
Error frames
Dropped frames
Undersized frames
Oversized frames
Bad EOF frames
Invalid ordered sets
Non-frame coding error
CNA port measures
Tx % utilization
Rx % utilization
Tx MBps
Rx MBps
Received paused frames
Transmitted paused frames
Received FCoE pause frames
Brocade Network Advisor SAN User Manual
53-1002696-01