Brocade Communications Systems StoreFabric SN6500B User Manual page 693

8. Select hosts using either of the following methods:
9. Click Next.
FIGURE 289
10. Enter the container name. The container name is a logical encryption name to specify a name
11. Click Next.
Brocade Network Advisor SAN User Manual
53-1002696-01
•
Right arrow button: Moves a host from the Host in Fabric table to the Selected Hosts table.
•
Left arrow button: Removes a host from the Selected Hosts table.
•
Add button: Click to manually add host port world wide names or host node world wide
names to the Selected Hosts table.
a. Select a maximum of 1024 hosts from the Hosts in Fabric table, then click the right arrow
to move the hosts to the Selected Hosts table. (The Port WWN column contains all target
information that displays when using the nsshow command.)
b. Manually enter world wide names in the Port WWN and Node WWN text boxes if the hosts
are not included in the table. You must fill in both the Port WWN and the Node WWN. Click
Add to move the host to the Selected Hosts table.
The Name Container dialog box displays
container that is created in the encryption engine to hold the target configuration data. The
name is only needed when configuring the storage using the command line interface (CLI).
The container name defaults to the target WWPN. You can, however, rename the container
name. Target container names can have up to 31 characters. Letters, digits, and underscores
are allowed.
Name Container dialog box
other than the default. You can use a maximum of 31 characters. Letters, digits, and
underscores are allowed.
The Confirmation screen displays
completes configuration of encryption engines, targets, and hosts.
Configuring encryption storage targets
(Figure 289). You can specify a name for the target
(Figure 290). The confirmation screen confirms and
20
645