Brocade Communications Systems StoreFabric SN6500B User Manual page 934

28
FC troubleshooting
ATTENTION
If you run more than one test per slot, the result may go wrong or the test may fail.
TABLE 77
D-Port test support matrix
D-Ports Tests Fabric OS 7.0
E-Port
Electrical Test Supported
Optical Test Supported
Link Configuration Not supported
Traffic
Test Supported
Test
Link Distance
Supported
Link Measurement
Not supported
To run a diagnostic port test, complete the following steps.
1. Select Configure > FC Troubleshooting > Diagnostic Port Test.
2. Select the ports for which you want to run a diagnostic port test from the Available Ports table.
3. Click the right arrow button to move the ports to the Selected Ports table.
4. To configure parameters for the link traffic test, select the ports for which you want to configure
5. Click Start.
886
Fabric OS 7.1
E-Port
Supported
Supported
Supported
Supported
Supported
Not supported
The Diagnostic Port Test dialog box displays.
You can only run 10 diagnostic port tests at a time. If you select more than 10 ports, the
Management application runs the first 10 diagnostic port tests and queues the rest. When the
first test is completed, the next test in the queue begins and so on until all tests are completed.
link traffic test in the Selected Ports table and click Link Traffic Test.
Refer to "Configuring link traffic test parameters"
The Management application performs the following operations to enable diagnostic mode on
the selected ports:
1. Disable the source port.
2. Disable the destination port.
3. Enable the diagnostic mode on source E-port.
4. Enable the diagnostic mode on destination E-port.
5. Enable the source port.
6. Enable the destination port.
The following tests are performed on the selected ports:
The following tests are performed on the selected ports:
•
Electrical loopback (16 Gbps only)
•
Optical loopback (16 Gbps only)
F-Port AG N-Port
Supported Supported
Supported Supported
Supported Supported
Supported Supported
Supported Supported
Supported Supported
on page 889.
HBA driver 3.2
ICL-Port
Not supported Supported
Not supported Not supported
Supported Not supported
Supported Not supported
Supported Not supported
Supported Not supported
Brocade Network Advisor SAN User Manual
53-1002696-01