Restoring Data To A New Server; San Display Settings; Setting Your Ficon Display - Brocade Communications Systems StoreFabric SN6500B User Manual

5

SAN display settings

5. Browse to the backup location.
6. Click Restore.

Restoring data to a new server

NOTE
The restore data files must use the exact directory structure as the backup directory structure (refer
to "Back up directory structure overview"
If your Management application server fails and you must recover information to a new server,
restore the data (Refer to

SAN display settings

You can configure the display for FICON and reset the display to the default settings.

Setting your FICON display

FICON display setup rearranges the columns of any table that contains end device descriptions to
move the following eight columns to be the first columns: FC Address, Serial #, Tag, Device Type,
Model, Vendor, Port Type, and WWN.
NOTE
You cannot set the FICON display for Professional and Professional Plus software.
To set the FICON display, complete the following steps.
1. Select Server > Options.
2. Select SAN Display in the Category list.
84
Browse to the location specified in the Output Directory field on the Options dialog box -
Backup pane.
Upon completion, a message displays the status of the restore operation. Click OK to close the
message and the Server Management Console. For the restored data to take effect, re-launch
the Configuration Wizard using the instructions in
page 5.
"Restoring data"
The Options dialog box displays.
The SAN Display pane displays
"Launching the Configuration Wizard"
on page 78).
on page 83 for complete instructions).
(Figure 22).
Brocade Network Advisor SAN User Manual
53-1002696-01
on