Adding A Node To The Cluster - Brocade Communications Systems StoreFabric SN6500B User Manual

Adding a node to the cluster

Perform the following steps on the secondary KeySecure node when adding it to the cluster.
1. From the KeySecure Management Console, select the Device tab, then select Device
FIGURE 226
2. Under Join Cluster, enter the cluster information that you configured for the primary KeySecure
3. Enter the primary KeySecure node IP address and port number in the respective Cluster
4. Enter the Cluster Key File or browse to the file location.
5. Enter the Cluster Password, then click Join.
6. Verify that both KeySecure nodes are shown as Active.
Brocade Network Advisor SAN User Manual
53-1002696-01
Steps for connecting to a KMIP appliance (SafeNet KeySecure)
Configuration > Cluster.
The Cluster Configuration page displays
KeySecure Cluster Configuration page
node. (Refer to "Creating a cluster"
Member IP and Port fields.
You are returned to the Cluster Configuration page with the cluster information listed in the
Cluster Members table (Figure
(Figure 226).
on page 582.)
227).
20
589