Brocade Communications Systems StoreFabric SN6500B User Manual page 694

20
Configuring encryption storage targets
FIGURE 290
12. Verify the information is correct, then click Next, which creates the configuration.
NOTE
If you can view the VI/VT Port WWNs and VI/VT Node WWNs, the container has been successfully
added to the switch.
646
Confirmation dialog box
The screen contains the following information:
•
Encryption Engine: The slot location of the encryption engine.
•
Container Name: The logical encryption name used to map storage targets and hosts to
virtual targets and virtual initiators.
•
Target Device Port: The world wide name of the target device port.
•
Host Node WWN: The world wide name of the host node.
•
Host Port WWN: The world wide name of the host port.
•
Host Name: The name of the host.
The Configuration Status screen displays
container configuration. The target and host that are configured in the target container are
listed, as well as the virtual targets (VT) and virtual initiators (VI).
(Figure 291), which shows the status of the new
Brocade Network Advisor SAN User Manual
53-1002696-01