San End Node Display; Displaying End Nodes - Brocade Communications Systems StoreFabric SN6500B User Manual

5

SAN End node display

1. Select Server > Options.
2. Select SAN Display in the Category list.
3. Click Reset Display.
4. Click Yes on the reset confirmation message.
5. Click Apply or OK to save your work.

SAN End node display

The connectivity map can be configured to display or not display end nodes. This option enables
you to set the end node display for all newly discovered fabrics. Note that disabling end node
display limits the connectivity map to emphasize switch members only.

Displaying end nodes

To display end nodes when discovering a new fabric, complete the following steps.
1. Select Server > Options.
FIGURE 23
2. Select SAN End Node Display in the Category list.
3. Select the Show connected end nodes when new fabric is discovered check box to display end
4. Click Apply or OK to save your work.
86
The Options dialog box displays.
The display and view settings are immediately reset to the default display settings (as detailed
in the Default display Settings table
The Options dialog box displays
Options dialog box (SAN End Node Display pane)
nodes on your system.
NOTE
Before changes can take effect, the topology must be rediscovered.
(Table 19)).
(Figure 23).
Brocade Network Advisor SAN User Manual
53-1002696-01