Brocade Communications Systems StoreFabric SN6500B User Manual page 1011

8. To set policy monitors for hosts, select the Host Checks tab
Brocade Network Advisor SAN User Manual
53-1002696-01
c. If you selected the Check for redundant connections to neighboring switches (SAN only)
check, enter the minimum number of connections allowed between a switch pair in the
Minimum Connections field.
The default recommended is 2. Valid values are from 2 through 512.
d. Select the switches or routers to which you want to apply this policy in the Available
Switches/Routers list and click the right arrow button.
NOTE
You can use the All SAN Switches targets (under the Product Groups > System Product
Groups node) in the Available Switches/Routers list) for future provisioning. Select All SAN
Switches and click the right arrow button to apply this policy to all discovered switches.
The selected switches display in the Selected Switches/Routers list.
following steps.
FIGURE 415 Add Policy Monitor dialog box, Hosts Checks tab
a. Select the Check for redundant connections to attached fabrics check box to determine if
there are at least the minimum number of configured physical connections between the
host and the attached fabric.
The default is 2. For more information about this check and a fix for rule violations, refer to
"Host policy monitors"
b. Enter the minimum number of connections between the host and the attached fabric in
the Minimum Connections field.
The default is 2.
on page 955.
Adding a policy monitor
(Figure 415) and complete the
31
963