Brocade Communications Systems StoreFabric SN6500B User Manual page 538

17
Layer 2 access control list management
Creating a standard Layer 2 ACL configuration (Fabric OS)
To create a standard Layer 2 ACL configuration, complete the following steps.
1. Select the device and select Configure > Security > Layer 2 ACL > Product.
2. Select New from the Add list.
3. Select Standard from the Type list.
4. Enter a name for the ACL in the Name field.
5. Enter a sequence number for the ACL in the Sequence field.
6. Select Permit or Deny from the Action list.
7.
8. Select the Count check box to enable counting.
9. Click the right arrow button.
10. Click OK on the Add - Layer 2 ACL Configuration dialog box.
490
The Device_Name - Layer 2 ACL Configuration dialog box displays.
The Device_Name - Layer 2 ACL Configuration dialog box displays.
FIGURE 172 Device_Name
In the Source list, select one of the following options:
•
Any
•
MAC
Selecting MAC enables the Source field. Enter the source MAC address on which the
configuration filters traffic in the Source field.
Count specifies the number of times the ACL rule is applied.
The new ACL entry displays in the ACL Entries list. To create additional ACL entries, repeat
step 3 through step 9.
The new ACL configuration displays in the ACLs list. To create additional ACLs, repeat
through step 10.
- Layer 2 ACL Configuration (Standard) dialog box
Brocade Network Advisor SAN User Manual
53-1002696-01
step 2