Monitoring With Snmp; Snmp Configuration - Juniper NETWORK AND SECURITY MANAGER NSMXPRESS - QUICK START REV1 Quick Start Manual

NSMXpress Quick Start

Monitoring with SNMP

28
Figure 31: Edit RADIUS Server Dialog Box
Edit the parameters you want to change and click
3.
You can configure your NSMXpress appliance for SNMP monitoring from a network
operations server. The server can then issue periodic SNMP Get instructions to return the
status of the NSMXpress appliance.
You configure SNMP on the NSMXpress appliances with access credentials for either
SNMP v2c or SNMP v3. NSMXpress supports read-only access to the System Descriptor
(sysDescr) and Host Resource MIB.
This section provides instructions for configuring NSMXpress for SNMP monitoring. You
must provide access credentials for the SNMP server, a list of IP addresses from which
logon requests will be accepted, and the trap conditions to be reported to the SNMP
server.
To configure SNMP monitoring of your NSMXpress appliance, select System
Administration > SNMP Monitoring. The SNMP window appears. This window contains
the tabs described in the following sections:
SNMP Configuration on page 28
SNMP System Information on page 29
SNMP Trap Configuration on page 30

SNMP Configuration

To configure SNMP:
Select System Administration > SNMP Monitoring.
1.
Select the SNMP Config tab, which is shown in Figure 32 on page 29.
2.
.
Save
Copyright © 2010, Juniper Networks, Inc.