Chapter 9 Monitoring Policy Management - Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual

Chapter 9
Monitoring Policy Management
Monitoring Policy Management Overview
This chapter explains how to set a statistics baseline and use the show command to
display your policy configuration and monitor policy statistics.
This chapter discusses the following topics:
Monitoring Policy Management Overview on page 181
Setting a Statistics Baseline for Policies on page 182
Monitoring the Policy Configuration of ATM Subinterfaces on page 183
Monitoring Classifier Control Lists on page 184
Monitoring Color-Mark Profiles on page 187
Monitoring Control Plane Policer Information on page 187
Monitoring the Policy Configuration of Frame Relay Subinterfaces on page 188
Monitoring GRE Tunnel Information on page 190
Monitoring Interfaces and Policy Lists on page 191
Monitoring the Policy Configuration of IP Interfaces on page 193
Monitoring the Policy Configuration of IPv6 Interfaces on page 197
Monitoring the Policy Configuration of Layer 2 Services over MPLS on page 201
Monitoring External Parent Groups on page 203
Monitoring Policy Lists on page 204
Monitoring Policy List Parameters on page 209
Monitoring Rate-Limit Profiles on page 211
Monitoring the Policy Configuration of VLAN Subinterfaces on page 212
Packet Flow Monitoring Overview on page 213
You can set a statistics baseline and use the show command to display your policy
configuration and monitor policy statistics. When you set baseline statistics, you can
retrieve statistics beginning at the time when the baselining is set. The policy log rule
provides a way to monitor a packet flow by capturing a sample of the packets that
satisfy the classification of the rule in the system log. See JUNOSe System Event Logging
Reference Guide for information about logging.
Monitoring Policy Management Overview
181