Monitoring Pppoe - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Monitoring PPPoE

Use the commands described in this section to display information about PPPoE
interfaces and subinterfaces.
You can set a statistics baseline for PPPoE interfaces, subinterfaces, and circuits
using the baseline pppoe interface command.
You can use the output filtering feature of the show command to include or exclude
lines of output based on a text string you specify. See chapter Command Line Interface
in JUNOSe System Basics Configuration Guide for details.
NOTE: The E120 and E320 routers output for monitor and show commands is
identical to output from other E Series routers, except that the E120 and E320 routers
output also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
baseline pppoe interface
Example 4 Formats the PPPoE remote circuit ID value to include the
NAS-Identifier [32] RADIUS attribute with the agent-remote-id suboption of the
tags supplied by the PPPoE intermediate agent.
host1(config)#radius remote-circuit-id-format nas-identifier agent-remote-id
Example 5 Formats the PPPoE remote circuit ID value to include the
NAS-Identifier [32] RADIUS attribute with both the agent-circuit-id and
agent-remote-id suboptions of the tags supplied by the PPPoE intermediate agent.
host1(config)#radius remote-circuit-id-format nas-identifier agent-circuit-id
agent-remote-id
Example 6 Formats the PPPoE remote circuit ID value to use the format for
the dsl-forum-1 keyword. For details about how the router implements this
format, see "Format for dsl-forum-1 Keyword" on page 331.
host1(config)#radius remote-circuit-id-format dsl-forum-1
Use the no version to restore the default format, agent-circuit-id.
See radius remote-circuit-id-format.
Use to set a statistics baseline for PPPoE interfaces, subinterfaces, and circuits.
The router implements the baseline by reading and storing the statistics at the
time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.
You cannot set a baseline for groups of interfaces, subinterfaces, or circuits. You
must set them one at a time.
Chapter 10: Configuring Point-to-Point Protocol over Ethernet
Monitoring PPPoE
369