Monitoring Pos - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

Monitoring POS

Use the show interfaces pos command to display information about the POS
interface. You can set a statistics baseline for POS interfaces using the baseline
interface pos command.
You can use the output filtering feature of the show command to include or exclude
lines of output based on a text string you specify. See show Commands in JUNOSe
System Basics Configuration Guide, for details.
NOTE: The E120 and E320 routers output for monitor and show commands is
identical to output from other E Series routers, except that the E120 and E320 router
output also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
baseline interface pos
show interfaces pos
host1(config-if)#shutdown
Use the no version to restart a disabled interface.
See shutdown.
Use to set a statistics baseline for POS interfaces. The router implements the
baseline by reading and storing the statistics at the time the baseline is set and
then subtracting this baseline whenever baseline-relative statistics are retrieved.
Example
host1#baseline interface pos 8/0
There is no no version.
See baseline interface.
Use to display the configuration, state, and statistics for a POS interface.
To specify a POS interface for ERX7xx models, ERX14xx models, and ERX310
router, use the slot/port[.subinterface ] format.
slot Number of the chassis slot
port Port number on the I/O module
subinterface Number of the subinterface
To specify a POS interface for E120 and E320 routers, use the slot/adapter/port
format.
slot Number of the chassis slot
adapter Identifier for the IOA within the E320 chassis, either 0 or 1, where:
Chapter 11: Configuring Packet over SONET
Monitoring POS
371