Configuring Ip For A Lag Bundle; Configuring A Vlan Subinterface For A Lag Bundle; Configuring A Pppoe Subinterface For A Lag Bundle - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide

Configuring IP for a LAG Bundle

To configure IP for a LAG bundle, perform the following steps:
1.
2.

Configuring a VLAN Subinterface for a LAG Bundle

To configure a VLAN subinterface for the LAG bundle, perform the following steps:
1.
2.
3.
4.

Configuring a PPPoE Subinterface for a LAG Bundle

To configure a PPPoE subinterface for the LAG bundle, perform the following steps:
1.
2.
204
Configuring 802.3ad Link Aggregation
Specify the LAG bundle.
host1(config)#interface lag bundleBoston
Assign an IP address and mask.
host1(config-if)#ip address 192.5.127.8 255.255.255.0
Specify VLAN as the encapsulation method.
host1(config-if)#encapsulation vlan
Specify the VLAN subinterface for the LAG bundle by adding a unique subinterface
number to the LAG interface identification command.
host1(config)#interface lag bundleBoston.1
Assign a VLAN ID for the subinterface.
host1(config-if)#vlan id 203
Assign an IP address and mask.
host1(config-if)#ip address 192.168.1.1 255.255.0.0
Specify PPPoE as the encapsulation method.
host1(config-if)#encapsulation pppoe
Specify the PPPoE subinterface for the LAG bundle in either of the following
ways:
Use the interface lag command to add a unique subinterface number to the
LAG bundle name.
host1(config)#interface lag bundleBoston.2
Use the pppoe subinterface lag command to add a unique subinterface
number to the LAG bundle name.
host1(config)#pppoe subinterface lag bundleBoston.2